Non-Rotation Resistant High Performance Steel Wire Ropes

Non-Rotation Resistant wire ropes are used primarily when non rotating or rotation resistant characteristics are not required in multi fall reeving systems. Most of our special non rotation resistant wire rope designs were developed to out perform the more traditional 6 and 7 outer strand steel core wire rope constructions. Within the group or type we have two main possibilities for rope selection; ropes more suitable for general purpose applications and ropes that are more application specific.

Applications:

HD 8 K and HD 8 K PPI

Used where Non Rotating properties are not required- short fall length, multi fall reeving systems.
Lattice boom crane: boom hoist, main hoist (short fall length).
Tower crane: trolley rope.
Container crane: hoist ropes, trolley ropes, boom hoist.
Steel mill crane: hoist ropes.
Deck crane, offshore crane: boom hoist.
Mobile harbor crane and quarry dredge twin hoist systems: hoist ropes usually in pairs of left and right hand lay.
Can be considered for use where increased performance is desired over traditional 6 and 7 outer strand steel core wire rope constructions.
PPI core protection is standard and recommended, non-PPI version is available on request.

SC 8 and SC 8 PPI

Used in all the same applications as HD 8 K and HD 8 K PPI where the increased performance, endurance properties and high MBL of HD 8 K and HD 8 K PPI wire ropes are not desired or required.
Can be considered for use where increased performance is desired over traditional 6 and 7 strand steel core constructions.
Non PPI core is standard with PPI core protection being available on request.

LP 5

Special 5 strand construction developed for the powered suspended platform industry.
Specifically designed to replace and out perform the 4 and 6 outer strand ropes used for powered suspended platform applications.
Powered suspended platforms and gondolas: hoist rope.
Jaw pulling device: pulling rope.
Overhead hoist: can be considered for some hoist rope applications, usually in the smaller diameter range.

DP 8 K and DP 8 K PPI

Used where Non Rotating properties are not required and where fleet angles are small, in fixed or closed multipart reeving systems.
Boom hoist systems and pendant ropes
Overhead hoists.
Telescopic crane: boom retraction system.
Special application specific hoist rope.
Extremely high breaking load achieved due to special full parallel construction.
Great resistance to drum crushing in multi layer operations due to high filling factor.
High degree of flexibility due to special full parallel construction.
High endurance or high service life in terms of bending cycles achieved (bending fatigue resistance) when compared to wire ropes of 6,7 and 8 outer strand constructions that use more traditional type steel core arraignments.
Supplied with or with out PPI. PPI version should be highly considered due to the stabilizing effect of the plastic layer and for greater service life.
Due to the specific constructional properties of full parallel laid wire ropes: sensitive to induced torque and twist, low resistance to the fleet angle effect, Premier Wire Rope should be consulted to ascertain equipment / wire rope application suitability.

DP 10 K

Main properties are the same as DP 8 K offered in 10 outer strand construction.
Developed to fit specific OEM wire rope specifications / applications.